Chapter 15, Section 14

The Shrinking Transmitter: Why AM Sites Now Double as Backup Studios

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 15, 2026.

For most of broadcasting's history, the transmitter building had no spare room. Today many of them have enough empty floor to hold a studio, and that's exactly what's moving in.

Then: the transmitter was the building. A high-power tube AM transmitter was a physical monster. The high-voltage power supply alone (plate transformers, mercury-vapor rectifier tubes, oil-filled capacitors, and a modulation transformer that could weigh as much as a car) could fill a basement or an entire first floor. The rig ran on thousands of volts, threw off enormous heat, and many older sites needed a dedicated "filter room" or "air-mixing room" full of blowers just to push cooling air through it. At the extreme, WLW's 500,000-watt amplifier (see The Superpower Era) famously filled its own purpose-built building with a cooling pond out back. The transmitter didn't sit in the building so much as the building was wrapped around the transmitter.

Now: a couple of cabinets along one wall. Solid-state transmitters changed everything. They run far more efficiently, throw off a fraction of the heat, replaced the room-sized modulation transformer with digital/PDM modulation, and swapped the giant linear power supply for compact switching supplies. A 50 kW rig that once filled a hall is now a couple of floor cabinets you could walk past, built from hot-swappable modules and running cool enough that the old blower rooms sit empty (see The Transmitters That Pay for Themselves). They're so reliable that some stations no longer keep a full backup transmitter at all.

The space that opened up. Subtract the basement-filling power supply, the blower room, and the spare-parts hoard for a temperamental tube rig, and a typical transmitter building suddenly has room to spare. For years that freed-up space just filled with tenant gear: two-way radio, paging, cellular. But increasingly it's being put to a more useful purpose for the station itself.

The studio moves in. Stations now build a studio at the transmitter site, most often as a backup or auxiliary studio so the station can keep originating programming if the main studio, or the link feeding it, goes down in a fire, flood, or outage. The transmitter site is the one building the station absolutely cannot lose, it already has the antenna and (usually) a generator, so it's the natural place to put the "if all else fails" studio. For some smaller operations, the transmitter-site studio has simply become the studio.

The rule that made it easy. This was held back for decades by the FCC's main studio rule, adopted in 1939, it required every AM, FM, and TV station to maintain a staffed studio, with program-origination capability, in or near its community of license. On October 24, 2017 the FCC eliminated the rule (effective January 8, 2018), dropping the staffing and origination requirements and keeping only a local or toll-free phone number. With the rule gone, a station was free to consolidate, shed an expensive downtown studio, and run from the transmitter site or anywhere else.

The trivia. It's a full circle. In the earliest days there was no separate studio: you had to be right next to the transmitter to play the records and announce, because there was no reliable way to send program audio any distance. The studio and the transmitter only moved apart once telephone lines got good enough to relay programming from a downtown studio out to a transmitter in a field. Now the transmitter has shrunk to the size of a refrigerator, the wires have been replaced by IP links, and the main studio rule is gone, so the studio is quietly moving back out to the transmitter site where it started. Eighty years later, the smallest building on the property is becoming the whole station again.

Tube eraSolid-state era
Transmitter footprintRoom- or hall-filling; power supply alone could fill a basementA couple of floor cabinets along a wall
CoolingDedicated filter/air-mixing room with blowersBuilt-in fans; old blower rooms now empty
Spare floor spaceEssentially noneEnough for a studio
Typical use of the extra room(there wasn't any)Backup/auxiliary studio, sometimes the main one

Table 15.14-1

Sources: Radio World ("Selecting a New Transmitter"; "Rebuild That Relic of an AM Transmitter," Mark Persons) · Engineering Radio (transmitter-site design) · FCC Report & Order 17-137 (Elimination of the Main Studio Rule, Oct. 24, 2017) · CommLawBlog / Comm Law Center.

FOUR WAYS TO MAKE 50,000 WATTS: SAME POWER, SHRINKING IRON all drawn to the same scale 6 ft motor-generator sets 1930s water-cooled tubes, MG sets, a dedicated building ≈1,500+ sq ft (plus the cooling pond outside) 1960s air-cooled tube wall (one room of the building) ≈250 sq ft 1980s late tube era ≈80 sq ft Today solid-state, one cabinet ≈20 sq ft Where did the room go? The modern cabinet makes the same 50 kW in ~1% of the 1930s floor space: which is why so many AM transmitter buildings now have a backup studio where the rectifier room used to be.

Same watts, vanishing iron. Every transmitter above makes the identical legal maximum (50,000 watts) yet each generation needed a fraction of its predecessor's floor. The 1930s plant was an industrial installation: water-cooled tubes the size of fire extinguishers, motor-generator sets spinning out filament and plate supplies, a rectifier room, and often a cooling pond out back. Air-cooled tube designs of the 1950s to 60s collapsed that into one wall of cabinets; the last great tube rigs of the 1970s to 80s needed just a pair; and a modern solid-state transmitter (hundreds of small RF modules summed together) makes the full 50 kW in a single cabinet you could mistake for a server rack, efficient enough to skip the architectural cooling entirely. Footprints shown are representative orders of magnitude, not catalog specs. The punchline is in the story text: the floor space freed by shrinking transmitters (plus the 2017 end of the main-studio rule) is why the transmitter site quietly became the station's backup studio, bringing the oldest stations full circle to where broadcasting began.

Drawing 15.14-2

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.

More in Rules, Operations and Economics

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz