Chapter 2, Section 2

AM Band First Vertical Radiator: WABC 1931

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 16, 2026.

Walk past any AM station today and the tower you see is the antenna: the whole energized steel structure radiates the signal. It wasn't always so. Through the 1920s, broadcasters hung horizontal wire antennas ("flat-tops," "cages," and T-antennas) strung between two self-supporting towers, often perched on a rooftop beside the studio. The towers were just scaffolding; the wire did the radiating.

The man who upended that was Dr. Stuart Ballantine. His research pointed out the flaw hiding in plain sight: those support towers weren't neutral: currents induced in them distorted the radiation pattern. So why string a wire between towers at all? Why not drive a tower itself as the radiator? Bell Telephone Laboratories and Western Electric took the idea to the Blaw-Knox company in Pittsburgh, which built a low-capacitance tower, insulated from the ground at its base so the entire structure could be energized as an antenna.

The first one rose in 1931 at Wayne Township, New Jersey, for the Columbia Broadcasting System's New York flagship, the station called WABC, which would become WCBS in 1946. At roughly 665 feet it was a half-wave vertical radiator feeding 50,000 watts on 860 kHz, and it is widely credited as the world's first medium-wave insulated-base vertical radiator. It caused a sensation, earning a cover story in the November 1931 Radio-Craft. (Mind the call letters: this WABC is the CBS station that became WCBS, not today's WABC 770, which was WJZ until 1953.)

Before 1931: the wire is the antennaStationbuildingFlat-top wire radiatesDownleadTowers only holdthe wire upProblem: currents in the support towersbent the radiation pattern1931 WABC: the tower is the antennaFeedWhole steel tower radiatesabout 665 ft tallBlaw-Knox tower,insulated at its baseGuy wires brokenby insulatorsBase insulatorWayne Township, New Jersey: 50,000 wattson 860 kHz (the station later called WCBS)

Drawing 2.2-3

And yet, the first irony, it was slow to catch on. The half-wave height, and the diamond-shaped Blaw-Knox "cantilever" towers that followed, turned out to throw too much energy skyward, worsening the very nighttime fading engineers were trying to avoid; by the 1940s the industry had dropped the diamond design for shorter guyed masts. The idea that the tower could be the antenna stuck for good, but the specific tower at Wayne did not last long at all.

Because around 1941, CBS went chasing saltwater. The company bought a one-acre tidal rock in Long Island Sound (Little Pea Island, soon renamed Columbia Island) after test transmissions proved its seawater ground conductivity would blanket New York, New Jersey, and deep into Connecticut. With the 1941 North American Regional Broadcasting Agreement the station shifted from 860 to 880 kHz, a 410-foot top-loaded tower went up on the rock, and power arrived through underwater cables run out from New Rochelle. The pioneering New Jersey vertical radiator, barely a decade old, was abandoned, beaten not by a better antenna but by better dirt, or rather better water.

A few years later the signal hopped once more, to nearby High Island, where it joined 660 (the old WEAF, later WNBC, today WFAN) diplexed onto a single shared tower. That tower has its own dark footnote: a private plane fatally crashed into it in 1967, knocking the station off the air the day before WCBS launched its famous all-news format. The two clear-channel giants, 880 and 660, share that High Island tower in the Sound to this day, now the last AM transmitter site left within New York City limits. The tower that became the antenna ended its journey on a rock surrounded by saltwater, which, as every old AM engineer knew, was the best ground a signal could ever ask for.

Chapter 2, Section 2, Part 2

Tower Height & Signal Strength: Interactive

Set a frequency, slide the tower up and down, and watch where it lands on the curve, with a to-scale tower drawing, live numbers, and the universal field-vs-electrical-height relationship.

Tool 2.2-1

Chapter 2, Section 2, Part 3

AM Antenna Efficiency Calculator: Interactive

Set frequency, tower height, and ground-radial length, and watch the two halves of an AM antenna fight it out: the tower’s radiation resistance against the ground system’s losses. Where the explorer above shows the field-versus-height curve, this one adds the efficiency: shorten the tower and watch the radiation resistance collapse; thin out the radials and watch the signal bleed into the earth. It is the hands-on version of why the bottom of the band dies first.

Tool 2.2-2

Field & radiation-resistance model: base-fed monopole, sinusoidal current, perfect ground. Ground-loss model: K4ERO / ARRL Antenna Book, average soil. FCC minimum-efficiency floors per 47 CFR § 73.189; ground-system standard per § 73.190. N6JET.

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.

More in The Tower and Antenna

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz