Chapter 2, Section 12
Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 15, 2026.
Once a tower has to be made visible to aircraft, because it tops 200 feet, or reaches into the protected airspace around an airport (see The 200-Foot Rule): the FAA's Advisory Circular 70/7460-1M spells out how. There are two basic ways to make a structure conspicuous, and a given tower uses one system or the other: paint it, or light it with white strobes.
The traditional method is the candy-striped look: alternating bands of aviation orange and white, an odd number of them so that both the top and bottom band are orange. The bands are equal in width, roughly one-seventh of the tower's height, but never more than 100 feet nor less than 1½ feet each. Paint covers daytime visibility; after dark the same tower switches to red obstruction lights: a flashing red beacon at the top and steady red lights at the intermediate levels. This is the classic orange-and-white tower with the red light on top.
The modern alternative is high-output white strobe lights, bright enough to mark the tower by day without any paint at all. They come in two intensities: medium-intensity white strobes for towers roughly 200-500 feet, and high-intensity white strobes for towers above about 700 feet. A medium strobe flashes about 40 times a minute at 20,000 candelas in daylight, dimming to 2,000 at night; a high-intensity unit can reach 270,000 candelas by day. Choosing a white-strobe system, or a dual system, white by day and red by night) eliminates the painting requirement entirely. The appeal is maintenance: no bands to repaint as they fade, and no string of red side-lights to service. That's why many owners pick strobes, especially on harsh sites where paint weathers fast.
| System | Daytime | Nighttime | Painted? | Typical height |
|---|---|---|---|---|
| Paint + red lights | Orange/white bands | Red beacon + side lights | Yes | Any required height |
| Medium-intensity white strobe | White flashes | White (dimmer) or red | No | ~200-500 ft |
| High-intensity white strobe | White flashes | White (dimmer) | No | ~700 ft and up |
| Dual (white/red) | White flashes | Red lights | No | Common in urban areas |
Table 2.12-1
Drawing 2.12-2
A local example sits in the bayland flats of Hayward: the five-tower array of KTCT 1050 (the Bay Area's "KNBR 1050"). Each tower stands about 62 meters, roughly 203 feet, just over the 200-foot line, and the array sits less than two miles west of Hayward Executive Airport's runways (with Oakland International about five miles north), so the FAA evaluated the towers as aviation obstructions. Yet not one of the five is painted. Instead they carry white strobe lights (the no-paint option above), a choice stations often make to cut maintenance, doubly attractive on a salt-air site where paint weathers fast.
Sources: FAA Advisory Circular 70/7460-1M (Obstruction Marking and Lighting) · FCC Part 17 / Antenna Structure Registration · FCC facility ID 51188 (KTCT) ASR tower data · FAA airport data.
© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.
All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz