Chapter 14, Section 19

The Buzz That Ate the AM Dial: Radio Noise at Home

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 15, 2026.

Ask a longtime AM listener what changed, and the answer is often not the stations. It is the noise. A station that came in clean in 1985 now sits under a buzz, a hum, a frying sound or a steady hiss, and the station did nothing different. The noise is coming from inside the house, from the house next door, and from the poles on the street.

The AM band (530 to 1700 kHz) is more exposed to this than almost any other radio service. AM carries the program in the strength of the signal, so anything that adds energy at the same frequency gets heard as sound. FM ignores most of it. AM cannot.

Chapter 14, Section 19, Part 2

Where the Noise Comes From

Switching power supplies. The biggest change since the 1980s is the switching power supply. Old wall transformers were heavy, warm and quiet. Today almost everything that plugs in, from a phone charger to a TV to a laptop brick, uses a small supply that chops the power on and off tens of thousands of times a second. Each chop throws off radio energy, and the harmonics of that switching land right on the AM dial. One cheap charger across the room can wipe out the bottom half of the band.

LED bulbs. An LED bulb is a tiny switching power supply with a light on top. Most are quiet enough. Some are not, especially cheap imports and some dimmable bulbs on older dimmers. The Society of Broadcast Engineers told the FCC in 2014 that the limits LED bulbs must meet (FCC Part 15) run about 12 dB looser than the limits for fluorescent lights (FCC Part 18). ARRL, the national amateur radio association, tested bulbs and found most met the rules, but warned that the limits themselves are high enough to cause interference.

Solar inverters. Rooftop solar panels make DC power, and an inverter turns it into household AC. That conversion is done by fast switching, and a poorly filtered system can spray noise across AM and shortwave in daylight hours, then go quiet at night. ARRL says solar interference cases are rising. It also reports that the big makers, including SolarEdge, Enphase and Generac, have generally been cooperative in fixing them.

Motors with speed controls. Variable-speed washing machines, air conditioners, heat pumps, pool pumps and furnace blowers use electronic motor controllers that can draw 500 to 1,500 watts. SBE pointed out that these controllers fall under the "digital device" rules and are exempt from specific emission limits.

Grow lights. High-power grow light ballasts became a well-known source in the 2010s. In 2014 and 2015 ARRL filed formal complaints with the FCC about grow light ballasts it measured far over the legal limit, including complaints about retail sales at major home stores.

Power lines. Outside the house, the classic source is the power line itself. ARRL's power line guide explains that most of it is not the wires but a tiny spark across loose or corroded hardware on a pole: a loose pin, a ground wire touching a staple, a worn insulator. The spark fires near the peaks of the AC wave, so the buzz pulses 120 times a second. Rain often quiets it for a while because water shorts out the gap; wind makes it come and go as the hardware moves.

Cars and chargers. Electric vehicles are part of the story too. The electric motor drives in EVs are a big reason some carmakers dropped AM radios (see AM Radio in Cars). Wired home EV chargers vary by model and filtering. Engineers have also warned that future wireless EV charging pads can produce harmonics inside the AM band.

Neighbor A LED bulbs TV, chargers Your unit AM radio AM Neighbor B Solar inverter Heat pump Arcing hardware Shared walls put dozens of noise sources within a few feet of your radio, and the breaker test only works on the ones in your own unit.

Why townhouses and apartments are the hardest case. The noise comes from many places at once, most of them behind walls you do not control.

Drawing 14.19-1

Chapter 14, Section 19, Part 3

What It Sounds Like, and What It Usually Is

What you hearMost likely source
Steady buzz or hiss across much of the band, stronger at the low endSwitching power supplies: chargers, TVs, LED drivers, computer gear
Raspy frying buzz that changes with weather, quieter when it rainsArcing hardware on a power pole
Noise only in daylight, gone at nightSolar inverter (yours or a neighbor's)
Noise that comes and goes with people: evenings, weekendsHousehold devices being switched on and off
Short loud burstsAppliances with motors: hair dryer, vacuum, drill
Rising and falling whine, or a set of evenly spaced whistles across the dialMotor speed controllers, some chargers and dimmers

Table 14.19-2

Chapter 14, Section 19, Part 4

How to Find the Noise

The tool everyone uses, from the FCC to the power companies to ham radio operators, is a cheap battery-powered AM radio. The FCC's own consumer guide gives the same method:

  1. Tune a quiet spot near the low end of the dial, between stations, with the volume up so you can hear the noise clearly.
  2. Turn off the main breaker while listening on the battery radio. If the noise stops, the source is in your own home. If it keeps going, it is outside.
  3. If it is inside, turn breakers back on one at a time to find the circuit, then unplug things on that circuit one at a time.
  4. If it is outside, walk with the radio. The noise gets louder as you get closer. A radio with a built-in ferrite bar can also point the way: turn it until the noise drops to its quietest, and the source lies off the ends of the radio.
  5. If it follows the weather and not the time of day, suspect the power lines and call the power company. Most utilities have someone who handles radio noise complaints.

Chapter 14, Section 19, Part 5

What the Rules Say

Under FCC Part 15, devices that give off radio energy as a side effect must not cause harmful interference, and the person operating one must stop using it if the FCC orders it until the problem is fixed (47 CFR 15.5). For most household devices, the measured limit is on noise carried back down the power cord. Across most of the AM band (0.5 to 5 MHz), that limit is 56 dBµV for home devices. Most devices have no limit at all on what they radiate through the air below 30 MHz, a gap SBE has asked the FCC to close.

Power lines are treated as "incidental radiators" with no specific numeric limit. The utility must fix interference from its own equipment. ARRL reports that the FCC expects most power line cases to be resolved within about 60 days, but SBE told the FCC in 2014 that many cases go unresolved for years and that enforcement had relied almost entirely on the utilities' good faith.

In 2016 the FCC's Technological Advisory Council opened an inquiry into whether the radio noise floor is rising (ET Docket 16-191). NAB asked for a radiated limit of 0.025 mV/m at 10 meters to protect AM listeners. Radio World later reported that the FCC ended the council's work on the study. No new AM noise limits came out of it, and as far as this site can find, none have been adopted since.

Chapter 14, Section 19, Part 6

What Actually Helps

Chapter 14, Section 19, Part 7

When You Live in a Townhouse or Apartment

The hardest case is shared walls. The breaker test only covers your own unit. There may be dozens of sources within 20 feet, all running at once, and a loop's null can only aim at one of them. Many apartment and townhouse listeners find that no amount of work at home gets the noise low enough. What still works:

From the author. This one is personal. I live in a townhouse with many neighbors on every side, each with their own appliances, phones and electronics. AM listening at home is almost impossible. I used to have a shortwave receiver too, but the noise runs 20 dB over S9, which makes it close to useless. I have tried many of the steps above without much success.

So I do a lot of my AM listening in my vehicle at night. I take some extra time, find a quiet spot, and scan through the dial to see what I can hear. It is a great way to get away from the noise at my house, and because vehicle receivers are built for AM and FM reception, it is a pretty good way to explore the AM broadcast band.

That is a big part of why this page exists: if you are hearing the same thing, it is not your radio, and you are not alone. Chris

Sources: 47 CFR 15.5 and 15.107 (FCC Part 15 rules, via Cornell LII and eCFR); FCC consumer guide, "Interference with Radio, TV and Telephone Signals"; ARRL, "Radio Frequency Interference," "Power Line Noise," "Solar" and "Grow Lights and RFI" pages, and ARRL EMC Committee reports (2013 to 2015); Society of Broadcast Engineers comments to the FCC, reprinted in Radio World, "How to Improve Ambient Noise" (February 14, 2014); FCC Public Notice DA 16-676 and ET Docket 16-191 (noise floor inquiry), with coverage by SBE, Radio World and TV Technology; In Compliance Magazine, "Wireless EV Charging Could Pose Threat to AM Reception"; KiwiSDR public receiver list.

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.

More in The Listener's Side: Receivers and DXing

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz