Chapter 8, Section 11

Replacing an Aging Three-Tower AM Array: A 2026 Budget

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 17, 2026.

Many AM stations on the air today are broadcasting from towers built in the 1930s, 1940s, 1950s and 1960s. Steel can last a long time if it is cared for, but guy wires, anchors, insulators and foundations wear out, and sooner or later a tower has to be replaced. For a station with a directional array, that means replacing several towers, while somehow staying on the air. This page walks through what that takes, and what it costs in 2026.

How Old Are These Towers?

Some of the most famous AM towers in America are close to a hundred years old. WSM 650 in Nashville still uses its Blaw-Knox diamond tower from 1932, now about 808 feet tall. WLW 700 near Cincinnati uses its Blaw-Knox diamond from 1934, now about 740 feet. WBT 1110 in Charlotte still has one of its 1934 towers; Hurricane Hugo wrecked the other two in 1989, and they were rebuilt from the original plans. Only a handful of Blaw-Knox diamond towers, roughly six to eight, are still standing and in use.

Thousands of ordinary AM towers are 50 to 80 years old. There is no fixed lifespan: engineers say a well-kept galvanized tower can last for decades, while guy wires are often planned for replacement about every 25 years. What wears out is usually not the steel you can see, but the guy anchors rusting underground, cracked base and guy insulators, lightning damage, and old concrete. The tower industry's standard calls for a full inspection of a guyed tower at least every three years.

When an old tower fails, some stations do not come back. In December 2025, wind broke the insulators on KLOE 730 in Goodland, Kansas, a station on the air since 1948. Replacement insulators could not be found, the tower was not insured, and it fell days later. The owner said it would not be rebuilt, and KLOE went silent for good.

Our Example Array

Our station
FrequencyAbout 1000 kHz
Day5,000 watts, non-directional, on one tower (Tower 1)
Night5,000 watts, directional, all three towers
TowersThree guyed towers, 246 feet tall (a quarter wave at 1000 kHz), built in the 1950s
Ground systemStill good; reused under the new towers
PlanReplace one tower at a time, same spots, same heights, staying on the air

Table 8.11-1

At 246 feet the towers are over the FAA's 200 foot line, so each new tower needs FAA approval, FCC tower registration, red lights and orange and white paint, just like most older arrays.

The Rules: Why No Construction Permit, but an STA

FCC rules normally require a construction permit to build a new tower, with one exception: a replacement tower of identical height at exactly the same location (47 CFR 73.1690). Our station rebuilds each tower on the same spot at the same height, and the finished array must produce the same licensed pattern, so no construction permit is needed.

The station does need permission to run differently while the work goes on. FCC rules require a Special Temporary Authority, or STA, before planned work that will throw a directional array out of its licensed settings (47 CFR 73.62). An STA lasts up to 180 days and can be extended. The usual condition for running non-directional when the license calls for a directional pattern is to cut power to 25% or less, so the signal does not reach farther than it should in any direction. When WXXI 1370 in Rochester, New York rebuilt its array in 2022 and 2023, its 5,000 watt night signal ran at 1,250 watts on one tower under an STA.

No source we found describes a station building a temporary two-tower night pattern during a rebuild. Every case we found simply ran on one tower. A temporary two-tower pattern would need its own design and approval, then be thrown away weeks later. Engineers who decide how to stage a real project should confirm the STA plan with the FCC.

Step by Step: Staying on the Air

StageWorkDaytimeNightFCC
1. PrepareEngineering design, soil tests, FAA and county filings, order steel and insulatorsNormalNormalFile the STA
2. Replace Tower 2Take down old Tower 2, pour a new foundation, put up the new tower, reconnect the ground systemNormal, on Tower 11,250 watts, non-directional, on Tower 1STA
3. Replace Tower 3Same work on Tower 3Normal, on Tower 11,250 watts on Tower 1Same STA
4. Replace Tower 1The day tower comes down lastOn new Tower 2 or 3, non-directionalReduced power on new Tower 2 or 3Changed or extended STA
5. FinishRetune the tuning units and phasor, new sampling system and monitor, run the proofNormalFull three-tower pattern after the proofLicense application with the proof

Table 8.11-2

The day tower goes last, so daytime, when most people listen, stays normal for as long as possible. The final tuning and proof are done once, at the end, with all three new towers in place.

How long? Putting up a tower takes days to a few weeks, but each stage usually stretches to one to three months once foundations cure, insulators arrive, crews are scheduled and the weather cooperates. Frozen ground stops foundation work in winter. A realistic total is six months to a year, plus the final tune-up and proof. Some rebuilds take far longer: WXXI's STA began in January 2022, and its rebuilt towers were finished by May 2023.

The Budget

Each line shows a typical 2026 price. Many of these items have no published price list, so several lines are our estimates built from the published figures, and the right-hand column says which.

ItemCostWhere the figure comes from
Engineering, technical and design services
Consulting engineer for the whole project: plans the stages, prepares the STA requests, models the new array, oversees the work$40,000our estimate; FCC cost catalog ($1,000 to $2,750 a day)
Structural design of each new tower to today's code (TIA-222-H), three towers$30,000FCC cost catalog 2018 ($5,100 to $12,300 per study)
Soil tests for the three new foundations$12,000Wireless Estimator budget prices
Surveyor: staking each new tower on the exact old spot, and certifying the positions for the proof$4,000our estimate; 47 CFR 73.151(c)
FAA notice and FCC tower registration paperwork for three towers over 200 feet$7,500our estimate; FCC Form 854 has no fee
On-site technical work at each stage: detuning, setting up the temporary operation, retuning the tuning units (three stages)$22,500our estimate, about $7,500 a stage
The station's own contract engineer, on hand through the project$10,000our estimate
Final phasor tune-up for the three new towers$10,000our estimate
Method of Moments proof of the new array$12,000Radio World; our estimate
Subtotal: Engineering, technical and design services$148,000
FCC filings and permits
Special Temporary Authority (STA) requests, $325 each: one to start, one change when the day tower comes down, one extension$97547 CFR 1.1104 (fees raised May 2025)
License application after the proof: license fee $755 plus directional antenna fee $1,480$2,23547 CFR 1.1104
County building permits for three tower foundations$3,000our estimate
Subtotal: FCC filings and permits$6,210
Tearing down the three old towers
Taking down each old tower with a crane or gin pole, since a felled tower could hit its neighbors ($20,000 each)$60,000our estimate; crane rates from Wireless Estimator
Removing old guy wires and anchors, cutting off old foundations below ground ($5,000 each)$15,000our estimate
Testing for lead paint and handling it safely ($3,000 each)$9,000our estimate; Baltimore lead paint case, 2026
Scrap steel credit, about 2 to 4 tons per tower ($600 each)minus $1,800USGS scrap report; ROHN section weights
Subtotal: Tearing down the three old towers$82,200
Three new towers
New 246 foot guyed tower, installed: steel, base insulator, guy insulators, new guy wires, foundation, three guy anchors, erection crew ($140,000 each)$420,000owner estimates in Wireless Estimator, Radio Ink, Scripps; FCC cost catalog; ROHN prices
Red LED obstruction lights, required over 200 feet ($9,000 each)$27,000Dialight kit prices; Radio World; Wireless Estimator
Painting in orange and white, required with red lights ($5,500 each)$16,500Wireless Estimator, $19 to $25 a foot
Lighting choke or ring transformer to carry light power across the base insulator ($4,000 each)$12,000BSW (Kintronic choke); our estimate
Reconnecting the existing copper ground system at each new base ($5,000 each)$15,000our estimate; ground system reused
Bringing the crane and tower crew in three separate times instead of once$20,000our estimate; Wireless Estimator crane rates
Subtotal: Three new towers$510,500
Array equipment
Repair and retune the three tuning units ($3,000 each)$9,000our estimate
New sampling system: three current sensors and equal-length sample lines$6,800BSW (Delta TCT-1); our estimate
New antenna monitor (Potomac 1901-3)$14,850BSW list price
Transmission line repairs$5,000our estimate
Subtotal: Array equipment$35,650
Lost income while on reduced power
Lost ad revenue during about nine months of reduced night power (illustration: a station billing $600,000 a year loses about 5% of it)$22,500our illustration; Nielsen and Westwood One listening by daypart
Subtotal: Lost income while on reduced power$22,500
TOTAL TO REPLACE THE ARRAY$805,060

Table 8.11-3

Part of the jobCost
Engineering, technical and design services$148,000
FCC filings and permits$6,210
Tearing down the three old towers$82,200
Three new towers$510,500
Array equipment$35,650
Lost income while on reduced power$22,500
Total$805,060

Table 8.11-4

Where the $805,000 goes: replacing a three-tower arrayEngineering, technical and design$148,000 (18%)FCC filings and permits$6,210 (under 1%)Tearing down the three old towers$82,200 (10%)Three new towers$510,500 (63%)Array equipment$35,650 (4%)Lost income on reduced power$22,500 (3%)Total$805,060Figures from Table 8.11-4. Percentages are shares of the total.

Drawing 8.11-5

About $805,000 in all. That fits the real-world estimates we found: one owner whose 410 foot towers were felled by vandals in 2023 put the cost of a new guyed tower at $200,000 or more, and a four-tower array at $800,000 to over $1 million. The new towers themselves are about two-thirds of the bill. Engineering, permits and the proof add more than $150,000 on top.

What It Tells Us

Replacing an old three-tower array costs about $800,000, and that is with the land already owned and the ground system still good. Many AM stations today sell for a small fraction of that. So when an old array reaches the end of its life, owners face a hard choice: spend the money, cut back to one tower with low power at night, or go silent.

Many have already chosen one tower. When KCIM in Carroll, Iowa took down its 1949 towers in 2018, it replaced the array with a single new tower. WXLW in Indianapolis replaced its 1948 towers in 2015 and now runs 1,000 watts by day on one tower. WGHQ in Kingston, New York dropped to one tower rather than rebuild two from 1960. With so many arrays built in the 1940s to 1960s, this bill will reach more and more stations over the next several years. For why so many owners choose one tower, see The Economics of Cutting Night Power (Chapter 7, Section 6, Part 2), and for what it would cost to build a whole station new, see Building an AM Station From the Dirt Up (Chapter 15, Section 17).

Sources: FCC rules 47 CFR 73.1690 (when a construction permit is needed), 73.62 (STA before array work), 73.1635 (STAs), 73.1615, 73.1680 and 73.1560 (reduced and temporary operation), 73.151(c) and 1.30003 (Method of Moments proofs), 1.1104 (fees, as raised in May 2025), 17.4 and 17.7 (tower registration); FAA Advisory Circular 70/7460-1M and FAA lighting guidance; Wireless Estimator (WSJS towers and costs, January 2023; crane, painting and lighting prices; WLW 2021); Radio World (KFI tower 2008; WXLW 2015; KLIZ guy lines 2017; WJMC 2021; KYMN 2025; KLOE December 2025; Spokane tower March 2026; Baltimore lead paint settlement 2026); Fybush Site of the Week (WLW, WBT, WXXI 2022 and 2023); Inside Towers (KCIM, February 2018); Engineering Radio (WGHQ, June 2016); RadioInsight, radio-online, KCTV5 and nwksradio.net (KLOE, December 2025); Northpine (WMT, KFXN, WGBW); oldradio.com, Structurae and Wikipedia (Blaw-Knox towers, WSM); TV Technology (tower life, July 2015); Radio Ink and Scripps News (WJLX, 2024); FCC cost catalog (DA 18-1072); USGS iron and steel scrap report; BSW, 3 Star, Radioparts and GME Supply dealer prices; Kintronic; Nielsen via Westwood One (listening by daypart, October 2025). A note on the numbers: contractors rarely publish prices for AM tower work, so the demolition, insulator, erection, tuning and proof lines are our estimates built from the published figures, and the lost revenue line is an illustration. Most lines have fewer than five sources. Treat the total as a realistic range, not a quote.

More AM Radio Stories

AM Radio Facts and Trivia, the main page, with hundreds more records, oddities and firsts. Test yourself with the AM Trivia Challenge.

More in Sites, Towers and Survival

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.